Differences

This shows you the differences between two versions of the page.

--- construction:quality_assurance:nuremberg_case_study [2020/08/03 13:16] – [Summary: Experiences gained] wfeist
+++ construction:quality_assurance:nuremberg_case_study [2020/08/12 18:46] (current) – [Introduction] wfeist
@@ Line 3: / Line 3: @@
 ===== Introduction =====
-=== Demonstration project “Nuremberg, Jean-Paul-Platz 4": Modernisation using Passive House Components ===
+=== Demonstration project "Modernising a block of flats in Nuremberg" ===
@@ Line 9: / Line 9: @@
 The heating demand of this building was reduced from 200kWh/(m²a) (previous state) to less than 26kWh/(m²a) as shown in Fig. 1. Typical commonly available Passive House components were used for this.
 \\
-[{{ :picopen:figure1_protokollband24_quality_assurance_nuernmberg.png?direct&400|Figure 1: \\ The demonstration project "Nuremberg, Jean-Paul-Platz 4" belonging to the wbg Nuremberg, planning for the modernisation by the architect Burkhard Schulze-Darup}}]
+[{{ :picopen:figure1_protokollband24_quality_assurance_nuernmberg.png?direct&400|Figure 1: \\ The demonstration project "Nuremberg, Jean-Paul-Platz 4" belonging to the wbg Nuremberg, planning for the modernisation by the architect Burkhard Schulze-Darup, for a detailled description see also [[phi_publications:pb_24:modernising_a_block_of_flats_jean-paul-place_4_nuremberg|modernising a block of flats in Nuremberg]] }}]
 \\
 [[construction:quality_assurance:nuremberg_case_study:Examination of the external envelope using thermographic imaging]]\\